Support Cords

support-cord2The support cords are made of Kevlar with a UV resistant Dacron covering and are rated for over 800# strength to hold the spreader arms in position. There are seven long cords and one short one all precisely measured and fitted with stainless fixtures ready to slip on with no knots or adjustments needed.

Below at left is how each cord is attached to the end of the spreader arms. And below at right is how the cords are attached to the top of the center post of the hexbeam.

 

 

 

Marine grade stainless clamp secures the cords to the arms
Marine grade stainless clamp and “S” hook secure the radial support cords to the ends of the arms.
Watertight, reinforced cap anchors the radial cords that support the spreader arms.
Watertight, reinforced cap anchors the radial cords that support the spreader arms.

 

 

Translate »